Jet-powered Star Wars speeder bike constructed from repurposed hoverboard

Growing your talent set is all about pushing the boundaries of your present information and expertise, however that inevitably results in occasional failure. When that occurs, that you must know how one can pivot and full the mission. An incredible instance of that’s James Bruton’s Star Wars speeder bike constructed from a repurposed hoverboard.

Bruton began this mission with the thought of taking the electronics and motors from a hoverboard and reconfiguring them to create a self-balancing bike. His intention was to manage the motion by shifting his weight and by tilting the again half of the bike relative to the entrance half, so the hoverboard electronics would act similar to they usually would. However that proved to be very tough to journey, so Bruton needed to pivot to a brand new management methodology that might give him higher maneuverability.

To avoid wasting the mission, Bruton turned to an Arduino UNO Rev3. It displays the rotation angle and tilt angle of the handlebars utilizing potentiometers, then makes use of servo motors to tilt the hoverboard controller boards accordingly. So far as the hoverboard electronics know, that is simply the motion of the rider shifting their weight or shifting their toes. This causes the bike to roll side-to-side or rotate in place by means of enter by means of the handlebars.

The bike rides on omni wheels, so Bruton additionally wanted a solution to transfer forwards. He selected to make use of pastime jet thrusters which might be additionally below the management of the Arduino, with a throttle turning a 3rd potentiometer. These thrusters don’t have fairly sufficient pressure for the job, so Bruton wants a push to get began. However they do let him proceed on as soon as he’s shifting.